Introduced in 2002, the Wayne Dalton iDrive is an innovative and compact garage-door-opening system that mounts to the wall directly above your garage door. Unlike traditional chain-, screw- and belt-drive garage door openers, iDrive openers use cables and a powerful motor to lift the door from the bottom. The Wayne Dalton iDrive 3663-372 is operated using a hand-held, keyless entry remote. If the remote for your iDrive opener is malfunctioning, you can reprogram the device and have it working again in minutes.
Instructions
1. Pull down on the Emergency Disconnect Handle to move the garage door opener into the Manual Door Operated position.
2. Locate the red Program button on the front cover of the garage door opener's overhead motor unit.
3. Press and release the Program button to access the garage door opener's programming mode. The overhead motor unit will beep once.
4. Press and hold the largest button on your keyless entry remote to program it to your garage door opener. The overhead motor unit will beep to confirm that the remote has been successfully programmed. Release the button when you hear the beep.
5. Push up on the Emergency Disconnect Handle to move it back into the Motor Operated Door position.
Tips Warnings
Use this same procedure to program or reprogram up to six keyless entry remotes to operate your Wayne Dalton garage door opener.
Allowing more than 30 seconds to elapse between completing Steps 3 and 4 will cause the overhead motor unit to exit the programming mode.
